4808a1c026
This patch provides an "isp116x-hcd" driver for Philips' ISP1160/ISP1161 USB host controllers. The driver: - is relatively small, meant for use on embedded platforms. - runs usbtests 1-14 without problems for days. - has been in use by 6-7 different people on ARM and PPC platforms, running a range of devices including USB hubs. - supports suspend/resume of both the platform device and the root hub; supports remote wakeup of the root hub (but NOT the platform device) by USB devices. - does NOT support ISO transfers (nobody has asked for them). - is PIO-only. Signed-off-by: Olav Kongas <ok@artecdesign.ee> Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
48 lines
1.7 KiB
C
48 lines
1.7 KiB
C
|
|
/*
|
|
* Board initialization code should put one of these into dev->platform_data
|
|
* and place the isp116x onto platform_bus.
|
|
*/
|
|
|
|
struct isp116x_platform_data {
|
|
/* Enable internal resistors on downstream ports */
|
|
unsigned sel15Kres:1;
|
|
/* Chip's internal clock won't be stopped in suspended state.
|
|
Setting/unsetting this bit takes effect only if
|
|
'remote_wakeup_enable' below is not set. */
|
|
unsigned clknotstop:1;
|
|
/* On-chip overcurrent protection */
|
|
unsigned oc_enable:1;
|
|
/* INT output polarity */
|
|
unsigned int_act_high:1;
|
|
/* INT edge or level triggered */
|
|
unsigned int_edge_triggered:1;
|
|
/* WAKEUP pin connected - NOT SUPPORTED */
|
|
/* unsigned remote_wakeup_connected:1; */
|
|
/* Wakeup by devices on usb bus enabled */
|
|
unsigned remote_wakeup_enable:1;
|
|
/* Switch or not to switch (keep always powered) */
|
|
unsigned no_power_switching:1;
|
|
/* Ganged port power switching (0) or individual port
|
|
power switching (1) */
|
|
unsigned power_switching_mode:1;
|
|
/* Given port_power, msec/2 after power on till power good */
|
|
u8 potpg;
|
|
/* Hardware reset set/clear. If implemented, this function must:
|
|
if set == 0, deassert chip's HW reset pin
|
|
otherwise, assert chip's HW reset pin */
|
|
void (*reset) (struct device * dev, int set);
|
|
/* Hardware clock start/stop. If implemented, this function must:
|
|
if start == 0, stop the external clock
|
|
otherwise, start the external clock
|
|
*/
|
|
void (*clock) (struct device * dev, int start);
|
|
/* Inter-io delay (ns). The chip is picky about access timings; it
|
|
expects at least:
|
|
150ns delay between consecutive accesses to DATA_REG,
|
|
300ns delay between access to ADDR_REG and DATA_REG
|
|
OE, WE MUST NOT be changed during these intervals
|
|
*/
|
|
void (*delay) (struct device * dev, int delay);
|
|
};
|