1da177e4c3
Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
191 lines
5.5 KiB
C
191 lines
5.5 KiB
C
#ifndef __ASM_SH_SMC37C93X_H
|
|
#define __ASM_SH_SMC37C93X_H
|
|
|
|
/*
|
|
* linux/include/asm-sh/smc37c93x.h
|
|
*
|
|
* Copyright (C) 2000 Kazumoto Kojima
|
|
*
|
|
* SMSC 37C93x Super IO Chip support
|
|
*/
|
|
|
|
/* Default base I/O address */
|
|
#define FDC_PRIMARY_BASE 0x3f0
|
|
#define IDE1_PRIMARY_BASE 0x1f0
|
|
#define IDE1_SECONDARY_BASE 0x170
|
|
#define PARPORT_PRIMARY_BASE 0x378
|
|
#define COM1_PRIMARY_BASE 0x2f8
|
|
#define COM2_PRIMARY_BASE 0x3f8
|
|
#define RTC_PRIMARY_BASE 0x070
|
|
#define KBC_PRIMARY_BASE 0x060
|
|
#define AUXIO_PRIMARY_BASE 0x000 /* XXX */
|
|
|
|
/* Logical device number */
|
|
#define LDN_FDC 0
|
|
#define LDN_IDE1 1
|
|
#define LDN_IDE2 2
|
|
#define LDN_PARPORT 3
|
|
#define LDN_COM1 4
|
|
#define LDN_COM2 5
|
|
#define LDN_RTC 6
|
|
#define LDN_KBC 7
|
|
#define LDN_AUXIO 8
|
|
|
|
/* Configuration port and key */
|
|
#define CONFIG_PORT 0x3f0
|
|
#define INDEX_PORT CONFIG_PORT
|
|
#define DATA_PORT 0x3f1
|
|
#define CONFIG_ENTER 0x55
|
|
#define CONFIG_EXIT 0xaa
|
|
|
|
/* Configuration index */
|
|
#define CURRENT_LDN_INDEX 0x07
|
|
#define POWER_CONTROL_INDEX 0x22
|
|
#define ACTIVATE_INDEX 0x30
|
|
#define IO_BASE_HI_INDEX 0x60
|
|
#define IO_BASE_LO_INDEX 0x61
|
|
#define IRQ_SELECT_INDEX 0x70
|
|
#define DMA_SELECT_INDEX 0x74
|
|
|
|
#define GPIO46_INDEX 0xc6
|
|
#define GPIO47_INDEX 0xc7
|
|
|
|
/* UART stuff. Only for debugging. */
|
|
/* UART Register */
|
|
|
|
#define UART_RBR 0x0 /* Receiver Buffer Register (Read Only) */
|
|
#define UART_THR 0x0 /* Transmitter Holding Register (Write Only) */
|
|
#define UART_IER 0x2 /* Interrupt Enable Register */
|
|
#define UART_IIR 0x4 /* Interrupt Ident Register (Read Only) */
|
|
#define UART_FCR 0x4 /* FIFO Control Register (Write Only) */
|
|
#define UART_LCR 0x6 /* Line Control Register */
|
|
#define UART_MCR 0x8 /* MODEM Control Register */
|
|
#define UART_LSR 0xa /* Line Status Register */
|
|
#define UART_MSR 0xc /* MODEM Status Register */
|
|
#define UART_SCR 0xe /* Scratch Register */
|
|
#define UART_DLL 0x0 /* Divisor Latch (LS) */
|
|
#define UART_DLM 0x2 /* Divisor Latch (MS) */
|
|
|
|
#ifndef __ASSEMBLY__
|
|
typedef struct uart_reg {
|
|
volatile __u16 rbr;
|
|
volatile __u16 ier;
|
|
volatile __u16 iir;
|
|
volatile __u16 lcr;
|
|
volatile __u16 mcr;
|
|
volatile __u16 lsr;
|
|
volatile __u16 msr;
|
|
volatile __u16 scr;
|
|
} uart_reg;
|
|
#endif /* ! __ASSEMBLY__ */
|
|
|
|
/* Alias for Write Only Register */
|
|
|
|
#define thr rbr
|
|
#define tcr iir
|
|
|
|
/* Alias for Divisor Latch Register */
|
|
|
|
#define dll rbr
|
|
#define dlm ier
|
|
#define fcr iir
|
|
|
|
/* Interrupt Enable Register */
|
|
|
|
#define IER_ERDAI 0x0100 /* Enable Received Data Available Interrupt */
|
|
#define IER_ETHREI 0x0200 /* Enable Transmitter Holding Register Empty Interrupt */
|
|
#define IER_ELSI 0x0400 /* Enable Receiver Line Status Interrupt */
|
|
#define IER_EMSI 0x0800 /* Enable MODEM Status Interrupt */
|
|
|
|
/* Interrupt Ident Register */
|
|
|
|
#define IIR_IP 0x0100 /* "0" if Interrupt Pending */
|
|
#define IIR_IIB0 0x0200 /* Interrupt ID Bit 0 */
|
|
#define IIR_IIB1 0x0400 /* Interrupt ID Bit 1 */
|
|
#define IIR_IIB2 0x0800 /* Interrupt ID Bit 2 */
|
|
#define IIR_FIFO 0xc000 /* FIFOs enabled */
|
|
|
|
/* FIFO Control Register */
|
|
|
|
#define FCR_FEN 0x0100 /* FIFO enable */
|
|
#define FCR_RFRES 0x0200 /* Receiver FIFO reset */
|
|
#define FCR_TFRES 0x0400 /* Transmitter FIFO reset */
|
|
#define FCR_DMA 0x0800 /* DMA mode select */
|
|
#define FCR_RTL 0x4000 /* Receiver triger (LSB) */
|
|
#define FCR_RTM 0x8000 /* Receiver triger (MSB) */
|
|
|
|
/* Line Control Register */
|
|
|
|
#define LCR_WLS0 0x0100 /* Word Length Select Bit 0 */
|
|
#define LCR_WLS1 0x0200 /* Word Length Select Bit 1 */
|
|
#define LCR_STB 0x0400 /* Number of Stop Bits */
|
|
#define LCR_PEN 0x0800 /* Parity Enable */
|
|
#define LCR_EPS 0x1000 /* Even Parity Select */
|
|
#define LCR_SP 0x2000 /* Stick Parity */
|
|
#define LCR_SB 0x4000 /* Set Break */
|
|
#define LCR_DLAB 0x8000 /* Divisor Latch Access Bit */
|
|
|
|
/* MODEM Control Register */
|
|
|
|
#define MCR_DTR 0x0100 /* Data Terminal Ready */
|
|
#define MCR_RTS 0x0200 /* Request to Send */
|
|
#define MCR_OUT1 0x0400 /* Out 1 */
|
|
#define MCR_IRQEN 0x0800 /* IRQ Enable */
|
|
#define MCR_LOOP 0x1000 /* Loop */
|
|
|
|
/* Line Status Register */
|
|
|
|
#define LSR_DR 0x0100 /* Data Ready */
|
|
#define LSR_OE 0x0200 /* Overrun Error */
|
|
#define LSR_PE 0x0400 /* Parity Error */
|
|
#define LSR_FE 0x0800 /* Framing Error */
|
|
#define LSR_BI 0x1000 /* Break Interrupt */
|
|
#define LSR_THRE 0x2000 /* Transmitter Holding Register Empty */
|
|
#define LSR_TEMT 0x4000 /* Transmitter Empty */
|
|
#define LSR_FIFOE 0x8000 /* Receiver FIFO error */
|
|
|
|
/* MODEM Status Register */
|
|
|
|
#define MSR_DCTS 0x0100 /* Delta Clear to Send */
|
|
#define MSR_DDSR 0x0200 /* Delta Data Set Ready */
|
|
#define MSR_TERI 0x0400 /* Trailing Edge Ring Indicator */
|
|
#define MSR_DDCD 0x0800 /* Delta Data Carrier Detect */
|
|
#define MSR_CTS 0x1000 /* Clear to Send */
|
|
#define MSR_DSR 0x2000 /* Data Set Ready */
|
|
#define MSR_RI 0x4000 /* Ring Indicator */
|
|
#define MSR_DCD 0x8000 /* Data Carrier Detect */
|
|
|
|
/* Baud Rate Divisor */
|
|
|
|
#define UART_CLK (1843200) /* 1.8432 MHz */
|
|
#define UART_BAUD(x) (UART_CLK / (16 * (x)))
|
|
|
|
/* RTC register definition */
|
|
#define RTC_SECONDS 0
|
|
#define RTC_SECONDS_ALARM 1
|
|
#define RTC_MINUTES 2
|
|
#define RTC_MINUTES_ALARM 3
|
|
#define RTC_HOURS 4
|
|
#define RTC_HOURS_ALARM 5
|
|
#define RTC_DAY_OF_WEEK 6
|
|
#define RTC_DAY_OF_MONTH 7
|
|
#define RTC_MONTH 8
|
|
#define RTC_YEAR 9
|
|
#define RTC_FREQ_SELECT 10
|
|
# define RTC_UIP 0x80
|
|
# define RTC_DIV_CTL 0x70
|
|
/* This RTC can work under 32.768KHz clock only. */
|
|
# define RTC_OSC_ENABLE 0x20
|
|
# define RTC_OSC_DISABLE 0x00
|
|
#define RTC_CONTROL 11
|
|
# define RTC_SET 0x80
|
|
# define RTC_PIE 0x40
|
|
# define RTC_AIE 0x20
|
|
# define RTC_UIE 0x10
|
|
# define RTC_SQWE 0x08
|
|
# define RTC_DM_BINARY 0x04
|
|
# define RTC_24H 0x02
|
|
# define RTC_DST_EN 0x01
|
|
|
|
#endif /* __ASM_SH_SMC37C93X_H */
|